The Coralife Pulse 2600 DC Wavemaker with 2X 1300 DC Powerheads creates customized water patterns similar to reef currents and river flows found in nature. These pumps create wave motion throughout your tank to eliminate “dead zones” and improve overall water quality and health.
Four operational modes:
Continuous Flow Mode: Adjust either pump to flow from 40-100% of maximum power to eliminate specific dead zones or create more current for coral health.
Tidal Mode: The two pumps are positioned at opposite ends of the aquarium. Pump A runs at maximum flow while Pump B runs at low flow for 12-hour cycle. The two pumps then switch speeds after 12 hours so Pump A runs at low flow, while Pump B runs at maximum flow, simulating a natural tidal ocean current.
Turbulence Mode: Both pumps begin at the lowest flow settings and increases up to maximum flow, then power off for five seconds before repeating. The run time to get from the lowest to maximum flow can be adjusted from 10-60 seconds.
Continuous/Turbulence Mode: Pump A runs continuously from 40-100% of maximum power while Pump B is in Turbulence Mode.
Features:
- Eliminates dead zones
- Improves water quality and coral health
- For use in salt and freshwater environments
- Each of the two DC powerheads has a 1300 gph flow rate
- Each pump comes with a large suction cup for attachment to the aquarium wall
- The wavemaker is 5.25" X 3.5" X 1.75"
